The site for laying a turf lawn should always be prepared in the same way as for sowing seeds. Tervis is usually cut into strips three to one feet apart and rolled up like a Swiss roll! But sometimes they are cut one-foot square. The best turfs are fairly uniform in thickness.

It cannot be cheap and it complicates the job of laying the lawn. It is a good idea to trim lawns before laying them rather than trying to adjust the ground level when laying them. To do this, make a frame, a box with one end missing, roughly the same size as the grass pieces, but with a little more to make them easier to put in and out. If you are looking for the best sapphire grass then browse the internet for required results.

The sides of the box should be the required thickness of the grasses and those that are too thick can be slid into the box with the grass cut down. Any excess clay that jumps onto the box can be cut away with an old knife. Those that are too thin should be set aside or marked and when placed a little extra soil can be placed underneath them.

When they are distributed, carefully pile the lawn turves in a spot near the site of the lawn to avoid handling them unnecessarily. When you're ready, begin laying the pieces of turf on the prepared surface, making sure they're all the same way, with their edges facing up. Pack them as close to each other as possible. It's best to start at the edges of the lawn so that every fresh row of turves land on uncontaminated soil.

Use a plank as a walk from a stack of turves across the designated vertices. The joints of the second row of turves should come between the joints of the first row, not like bricks in the wall. Take the plank along as you work. Set aside any damaged lawn turves and use these to center. Use the good ones for the sides. If you notice the roots of any perennial weeds when you're laying the turf, it's usually fairly easy to pull them out.